Laser devices

Frequently asked questions

Understanding the Sparklike Laser Portable results

Adjusting the laser temperature

“Glass detection error” message

DAQ identification error message – Sparklike Laser Portable

How do I adjust the laser temperature?

How often I have to calibrate the Sparklike Laser™ devices?

How long it will take to set up the Laser Portable system for measurement?

Is there a difference of the measurement between Laser Portable™and Laser Integrated™?

How long does the battery last with the Laser Portable™?

For flushing, can I use other gas than argon?

How often I have to flush the measuring head?

Can I measure other gases than Argon with Sparklike Laser devices?

The Laser Portable device freezes up and then turns off when the following steps are taken: turn on I&R check, leave I&R on, turn on gas test. Gas test will not run and unit will shutdown. What is the issue here?

Why my measurement results are suddenly inconsistent?

I have internal oxygen concentration problems with the device. How do I solve that?

“Glass Detection Error” message appeared on my screen, what should I do?

My Laser Portable has drive error, what should I do?

I have error message “The laser temp or current is out of range”, what should I do?

The lights in the measuring head do not light up, what should I do?

My Laser Portable 2.0 device shuts down even when connected to external power supply, what can I do?

After being on for about 30 minutes, the Laser I&R output looks very different from the output in the manual. The measurements from the machine are accurate but varies a bit. Could this odd output be the issue, or is this level of performance expected?